About the Artist

Lighted Table Top Fountains

 Contact Us


 Fair Schedule 2004

Art Glass Fountain Information and Care Instructions

    1.USE ONLY DISTILLED WATER IN THE FOUNTAIN. Regular tap water will leave behind a white mineral salt which over time will build up on the glass and become very difficult to remove.

    2. Do not remove the drip loop. The loop is necessary to prevent water from running down the cord into your electrical outlet.

    3. Make sure the light is completely submerged under the water before plugging in the unit. Do not touch a lit lamp at the risk of personal injury.

    4. Do not let the pump run when not submerged in the water. Doing so may damage the pump. Always submerge the pump first, then plug in the transformer.

    5. The water level should be maintained at one-half inch below the top of the fountain. If you hear a chugging noise, it means the pump is pumping air. You need to add more water to the fountain.

    6. Do not plug-in or otherwise use this product if any part of it appears to be damaged or operates abnormally. Have the product examined and repaired if necessary by a qualified electrician.

    7. Do not store fountain or fountain parts in extremely hot or extremely cold places.

        Fountain Cleaning Instructions

        a) Unplug the fountain.

        b) Remove each plate and spacer and wash them with soap and warm water in the sink. Don't put them in the dishwasher.

        c) Remove the fountain/light assembly and rinse it under warm water.

        d) Clean the plastic tube with a long, thin brush.

        e) Wash gently and rinse the bowl. Be careful not to loosen the seals on the seams of the bowl.

        f) Reseat the pump/light at the bottom of the bowl.

        g) Press one end of the plastic tubing into the top of the pump.

        h) Replace the larger glass plate making sure that the plastic tubing fits up through the hole in the center and the cord feeds through the notch on the edge of the plate. This notch will be at the back of your fountain.

        i) Slide spacer down tubing until it rests on the larger plate. (some models).

        j) Run the plastic tubing up through the hole in the center of the second plate and set it gently on top of spacer. If fountain has additional plates, repeat steps i and j.

        k) Fill the fountain within one-half inch of the top with DISTILLED water.

        l) Plug-in and enjoy.

        WARRANTY: The pump/light combo is warranted for 12 months after purchase. If either should fail, contact us for a replacement. After twelve months, you may purchase a replacement from www.artisticdelights.com. Look for “Low Voltage Pump and Light Combo FQ-508E”.